If you burn wood in Lawrence, Indiana, creosote is building up in your flue right now. Our fireplace inspection and cleaning Lawrence IN service covers the firebox, damper, flue tiles, cap and crown, then sweeps every surface clean. We also offer a fireplace check and sweep Lawrence homeowners book each fall. One visit, no mess, and a written report on what we found.
Tell us what is happening. Our local team will confirm your visit shortly.
Call Now (855) 959-5820 → No spam. No obligation. Just practical help.
fireplace inspection and cleaning Lawrence IN is a two-part service: a level-one or level-two inspection of the entire venting system, followed by a mechanical sweep of the firebox, smoke chamber and flue. We run an inspection camera up the flue to check flue tiles for cracks, gaps and offset joints, then use chimney rods and a chimney brush sized to your flue. An ash vacuum and HEPA vacuum capture the dust so your living room stays clean.
Lawrence homes take a beating from wood smoke. Most of the housing stock around Old West Lawrence and the Pinckney Neighborhood was built before 1960, and original firebrick and mortar joints are often soft enough that a wire brush alone will damage them. That is why we hand-scrape those flues first. If you have been searching for fireplace inspection and cleaning near me Lawrence IN, book before the first cold snap, because October through December fills up fast.
A standard visit covers the full venting system from the firebox to the chimney cap. We inspect, sweep, vacuum and document. Anything beyond that, like masonry rebuilds or liner replacement, gets priced separately and only after you approve it.
Chimney rods and a brush sized to your flue remove soot and creosote from the firebox through the smoke chamber and up the full flue run. Glazed deposits get a rotary whip or creosote sweeping log treatment. Roughly 45 to 60 minutes for a standard residential flue.
An inspection camera travels the flue to check flue tiles for cracks, gaps, spalling and offset joints. We photograph anything questionable. This is the step that catches damaged flue liner problems before they turn into a carbon monoxide issue.
We scrape the firebox, vacuum the smoke shelf, and check the damper for proper seal and operation. Firebrick and mortar joints get a visual check for heat damage. Sticking dampers get lubricated or flagged for replacement.
From the roof we inspect the chimney cap, cap screen and crown for cracks, rust and animal damage. A cracked crown lets water into the masonry, which is the leading cause of chimney leak calls we get in Lawrence.
A HEPA vacuum runs at the firebox for the entire job, and we lay drop cloths from door to hearth. All soot and debris leaves in sealed bags. When we are done, your fireplace area looks the way it did before we arrived.
You get a written summary with the sweep date, what we found, and photos of any issues. It is useful for insurance, home sales and your own records. We also note the next recommended service date.
We lay drop cloths from the front door to the hearth and seal the firebox opening with a HEPA vacuum running the whole time. Setup takes about 10 minutes. You will not find soot on your carpet or furniture when we leave.
Before any sweeping, we inspect. An inspection camera goes up the flue to check flue tiles, mortar joints and the smoke chamber. We check the firebox, damper, chimney crown, cap and exterior masonry. This takes 20 to 30 minutes and drives everything that follows.
Chimney rods and a poly or wire brush sized to your flue sweep the full run. Stubborn glazed creosote gets a rotary whip or a creosote sweeping log treatment. A Sooteater rotary system handles tight offsets that a straight brush cannot reach. Roughly 45 to 60 minutes for a standard flue.
Soot, ash and creosote go into sealed bags and leave with us. We vacuum the firebox and smoke shelf with an ash vacuum, then wipe the glass and surround on wood stoves. Nothing gets left in your trash or on your lawn.
We show you photos of anything we found, explain what it means, and give you a written report with the sweep date. If a repair is needed, you get a clear price before we schedule it. Most visits wrap in 90 minutes to two hours.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
The core sweep setup. Rods extend up the flue and the brush is sized to your flue dimensions so it contacts all four sides without damaging flue tiles.
A flexible rotary whip for flues with offsets or heavy glazed creosote that a straight brush cannot reach. Common in older Lawrence homes with angled smoke chambers.
Pushed up the flue to record video and stills of flue tiles, mortar joints and the smoke chamber. This is what turns a sweep into a real inspection.
HEPA containment at the firebox keeps fine soot out of your living space. The ash vacuum handles bulk ash removal from the firebox and smoke shelf.
A Rutland-style chemical log that dries and fractures glazed creosote so it can be brushed out. Used selectively, not as a substitute for mechanical sweeping.
For soft firebrick and old mortar joints where a stiff brush would do damage. We hand-scrape first, then finish with a soft brush.
Laid from the door to the hearth and sealed around the firebox opening. The reason customers say we leave no trace behind.
A homeowner in Old West Lawrence had not had the chimney swept in four years. The flue carried a quarter inch of creosote, the damper stuck halfway open, and smoke rolled into the room on every fire. The cap screen was half blocked with leaves.
We hand-scraped the soft firebrick, swept the full flue, cleared the cap screen and lubricated the damper. Draft tested normal afterward. The homeowner lit a fire that evening with no smoke in the room for the first time in two seasons.
A Prairie Park homeowner was burning nearly three cords a winter and still could not heat the main floor. The stove pipe had heavy creosote at the first elbow, and one liner joint had separated enough to leak. Draft was weak.
We swept the stove pipe and flue, re-seated the liner joint and replaced the cap screen. Draft improved immediately. The homeowner reported burning about 20 percent less wood the following winter for the same heat.
A small chimney fire self-extinguished in a home near the Schwegler Neighborhood. The owner had not had it inspected. By the next fall there was a visible crack in one flue tile and a warped damper that no longer sealed.
Our level-two camera inspection found the cracked tile and the warped damper. We documented both with photos, replaced the damper, and installed a stainless steel liner to restore the flue. The fireplace was back in service before winter.
Most chimney calls start with one of these five symptoms. Each one has a cause we can find and a fix we can price on the spot.
Ask a pro →We camera the flue, check the cap screen for animal nest debris, test draft and inspect the damper seal. Most backdraft cases in Lawrence trace back to a blocked cap screen or a flue that has never been swept. Both are fixed in one visit.
We remove it mechanically with brushes and a rotary whip, and treat hard glazed deposits with a creosote sweeping log where appropriate. After the sweep we show you photos of the clean flue so you know exactly what condition it is in.
We inspect the crown, cap and flashing from the roof, then trace the leak path. Crown sealing and cap replacement solve most cases. If the flashing has failed, we tell you and coordinate the repair rather than guessing.
We sweep the stove pipe and flue, check liner joints and the appliance connection, and verify the cap screen is clear. Customers routinely report burning 15 to 20 percent less wood after a proper sweep and draft check.
Typical 2026 pricing in Lawrence runs $189 to $349 for a standard sweep with a level-one inspection, and $275 to $450 when a level-two camera inspection is needed. Add-ons like a chimney cap replacement or crown repair are quoted separately before we start. If we find a damaged flue liner, we price the repair on the spot so you are not guessing.
Every visit includes a full inspection of the firebox, damper, smoke chamber, flue tiles, chimney crown and cap, followed by a mechanical sweep of the flue and firebox. We vacuum with a HEPA unit, remove all debris, and leave a written report with photos. Draft testing and a cap screen check are standard. Masonry repairs and liner replacement are separate.
Once a year if you burn wood regularly, and that is the NFPA 211 recommendation. If you burn more than one cord a season, or you notice smoke rolling into the room, book a second look mid-winter. Homes that only burn a few decorative fires can stretch to every 18 months, but the annual fireplace inspection and cleaning Lawrence IN visit is the safe default.
Yes. Wood burning fireplaces, inserts and freestanding wood stoves are our main work. We size the brush to your flue, hand-scrape soft firebrick, and treat glazed creosote with a rotary whip or creosote sweeping log. If your stove has been burning cold and smoking, we will check the liner and cap screen on the same visit.
Chimney sweep near meA straight sweep without the full inspection report. Best when you had an inspection recently and just need the flue cleaned before winter. We still check the cap and damper while we are up there.Explore →
Emergency Chimney sweepFor smoke backdraft, a suspected chimney fire, or a flue blocked by an animal nest. We prioritize these calls and can often be on site the same day anywhere in Lawrence and Marion County.Explore →
24/7 chimney sweepAfter-hours and weekend dispatch for urgent chimney problems. If you smell smoke in the house at 2 a.m. in January, call and we will talk you through shutting the appliance down safely.Explore →
chimney cleaningThe core flue and firebox cleaning service, using chimney rods, brushes and HEPA vacuuming. Pairs naturally with our inspection and cleaning visit if you want both done in one trip.Explore →
chimney cleaning near meLocal crews serving Lawrence, Marion County and the surrounding neighborhoods. We route trucks by ZIP so your appointment window stays tight instead of a four-hour wait.Explore →
fireplace cleaningFirebox, glass, surround and hearth cleaning for wood and gas fireplaces. We remove soot staining, ash residue and creosote flakes so the unit looks and drafts like it should.Explore →
chimney inspectionLevel-one, level-two and multi-point inspections with camera work. This is the service that catches damaged flue liners, masonry cracks and crown failures before they become expensive.Explore →chimney inspection near meCamera-based inspection for Lawrence homes, including real estate transactions and post-chimney-fire assessments. You get photos and a written summary you can hand to an insurer.Explore →Creosote does not wait for a convenient week. Call EmberHarbor Pros at (855) 959-5820 and we will get your sweep on the schedule, usually within the same week. CSIA Certified sweeps, upfront pricing, and a written report when we finish.
Schedule My Sweep (855) 959-5820 →Call (855) 959-5820 or email info@emberharborpros.com and we will get back to you the same business day. Our phones are answered Monday through Friday, 8 a.m. to 6 p.m., and the emergency line stays open 24/7 for chimney problems in Lawrence. Same-day slots are often available if you call before noon.